Maintenance; Water Suction Filter Checking - Lavor INDEPENDENT 2800 Translation Of The Original Instructions

11).
CLOSE
NOTE: Do not the choke if the engine is warm
or the air temperature is high.
8. Start the engine (Fig. 13).
ON Engine switch
fig. 13
a) Push the engine switch to the ON position.
b) Pull slightly the starting rope handle up until fee-
ing anti-action, and then make a rapid pull.
•CAUTION: Return the starting rope handle gently
to prevent damage to the starter.
9. Preheat the engine and push back the choke lever
to "OPEN" (Fig.14).
fig. 14
•CAUTION: Do not allow pressure washer to idle
for more than 2 minutes without switching off.
Failure to do this could cause appliance to the
malfunction.
II. STOP
In an emergency, push the engine switch to "OFF"
to stall the engine. Stop it in normal in the following
sequence:
16
Chock lever
OFF
fig. 11
Starting rope handle
Choke lever
OPEN
1. Push the engine switch to the OFF position (Fig.
15).
OFF
fig. 15
2. Set the fuel cock to the OFF position (Fig. 16).
fig. 16
•CAUTION: Turn off the machine when finished
working.
•CAUTION: When the machine is switched off, al-
ways discharge the pressure hose, opening the
gun.

MAINTENANCE

•CAUTION: Before to carry out any kind of main-
tenance to the washer machine, run the pres-
sure down, take the water connection out.
I. LUBRICATION
Motor: see "owner's manual - general gasoline en-
gine".
High-pressure water pump: Pump Maintenance:
We recommend the replacement of the oil pump
every 100 working hours.
Use oil type 15W-40, 55ml.
II. WATER SUCTION FILTER CHECKING
Check periodically in order to avoid deposits clog-
ging it (fig. 17).
Engine switch
OFF