Initial Operation; Equipment Inspection; Mounting Accessories; General - Atmos MEDAP LS FLOW Operating Instructions Manual

3

Initial operation

Equipment inspection

3 Initial operation
3.1 Equipment inspection
 Check whether all tubes are undamaged.
 Check whether the unit has been properly cleaned and that there are no residues or soiling.
 Do not use damaged components.
3.2

Mounting accessories

3.2.1

General

3.2.2

Connection of bubble humidifier (REF 5752 5315)

3 3
Fig. 2: Connection of bubble humidifier
3.2.3

Connection of disposable humidifiers from other manufacturers

Disposable humidifiers complying with the interface description may be connected to the
flowmeter outlet.
 Screw the disposable humidifier directly to the flowmeter output (2) and tighten finger-tight
until it stops.
14
GA 5752 5678 GB 07
DANGER!
Product inspection!
Only product parts which are in perfect condition can ensure proper functioning of
the product. The product parts will thus have to be carefully inspected before
mounting.
WARNING!
Tensile forces!
The connected accessories must not exert any mechanical forces which could
adversely affect the secure fit of the product.
1 1
2 2
Connecting the bubble humidifier
 Ensure that the cap nut of the humidifier
and the angled adapter contain a flat seal.
 Fill the humidifier bottle up to the marking
'Filling level' with distilled water and screw
the bubble humidifier cap into place.
 Screw the angled adapter (1) to the
flowmeter output and tighten finger-tight
until it stops.
 Screw the bubble humidifier cap (3) to the
angled adapter (1) and tighten finger-tight
until it stops.
 Pay attention that no tensile forces affect
the bubble humidifier.