Insportline ELBE–IN 2846 Manual page 41

5
STEP 5
1. Connecting the sensor wires which are on the rail and main housing together, then slide the
aluminum rail (#5) into the main housing and bolt into place using the fixing bolt (#27), once the
bolt is slotted through the nearest pre-drilled hole to the main housing attach the washer (#16)
and the thin nylon nut (#17). Using the second pre-drilled hole away from the main housing slot
through your pull pin (#27). Finally, screw the fixing knob into the aluminum rail (#5) using the
pre-drilled hole provided.
2. Connect the sensor wire and place the monitor (#11) onto the main frame.
PARTS:
#16 #17
11
17
16
#27
27
26