Chapter 2 Parameters Setup App; Mobile Phone App; Mobile Phone App Installation; Mobile Phone App Connection - RadioLink T8FB User Manual

⑤ When the LED stops flashing and turns to always on, binding is complete. If not succeed,
the LED will keep flashing slowly to notify, repeat the above steps.
Check the binding tutorial here:

2.1 Mobile phone APP

2.1.1 Mobile Phone APP Installation

Android APP: Visit
download the android APP to setup T8FB parameters by
Bluetooth connection.
NOTE: The APP will not collect any user's information, you
can even use this APP without Internet connecting. The APP
asked for Location Permission only used for connecting and
telemetry function.
Apple APP: Search Radiolink in Apple store and then click it to download.

2.1.2 Mobile Phone APP Connection

Connection of both Android APP and Apple APP to T8FB are the same as below:
① When the installation of parameter setup APP is complete, push the power button to turn
on T8FB.
② Click to enter the APP, a message will pop out to ask for permission to turn on the
Bluetooth function.
③ Click CONNECT on the top left of interface, a list of devices will pop out for selection.
④ Select RadioLink device, the two LED indicators at rightmost will flash with DD sounds.
https://www.youtube.com/watch?v=D2cwvloIMDM

Chapter 2 Parameters Setup APP

https://www.radiolink.com/t8fb_bt_app
to
10
RadioLink Electronic Limited
www.radiolink.com