Working Mode; How To Turn On Gyro Function - RadioLink RC4GS Instruction Manual

R6FG with two indicate LEDs, while green LED is on, it indicates normal working mode. While both
green and red LEDs are on, it indicates gyro function working mode.

3.2.2 Working Mode

R6FG has two working modes: normal working mode and gyro function working mode.
Normal Working Mode
Green LED, gyro will not working.
Gyro Function Working Mode
Both green and red LED on.
Receiver with gyro integrated to hold the vehicle in a straight line during aggressive acceleration
and braking or get bumped around by rough terrain.
Receiver with gyro integrated to keep the uni-direction and anti-slip.

3.2.3 How to Turn On Gyro Function

Quick press the ID SET switch two times within 1 second, the LED change from green to red means gyro
function has turn on.
Gyro Function Setup
Integrated Gyro, is used to assure the stability of cars on turning status; and keep on straight running
even the cars get some mechanical phantom. Gyro function can be enabled
A. Gyro enabled
Gyro preset disabled, and it enters post indication status. There are two indicators on the receiver. The
green one shows the receiver status and the red one is for gyro. When the led turns on, the gyro
is enabled, and the led turns off, gyro disabled.
B. Gyro enabled forward
Cars can be drove forward and backward; gyro is enabled forward or backward correspondingly. Like
the EP cars, different connection will make different direction, the gyro is ensured to be enable
forward.
C. Gyro reverse
Same like a plane has reverse, car kit gyro has reverse as well. Only right set reverse gyro can act to
correct.
Setup
(1) Enable gyro
Press binding key three times (interval less than 1 second) , the red LED will flash three times,
indicating whether gyro is enabled.
(2) Gyro sensitivity
Gyro sensitivity is predefined to adjust by channel three (factory set VR function) , turning the
VR switch clockwise to raise sensitivity and anti-clockwise to decrease.
(3) Gyro forward
7
or disabled.