Steering Exp "Stexp - RadioLink RC4GS Instruction Manual

4C-DWN: 4th channel (down)
Steering EPA
ST-LFT:0%~120% ST-
RGT:0%~120% Initial
value: 100%
Aux Servo EPA
3C- LFT:0%~120%
3C-RGT:0%~120%
Initial value: 100%
End point adjustment
(1) Access the function menu (By pressing "Exit" and "Enter" buttons simultaneously and holding
them down for one second), press "Inc(+)" button twice to chose EAP function.
(2) Press "Enter" button to get into EPA function interface, use "Dec(-)" or "Inc(+)" button to
select the desired setting item , press "Enter" key, the initial value of your selected setting item will
blink, then you can press "Dec(-)" or "Inc(+)" button to adjust the value of your selected setting
item.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing "Dec(-)"
and "Inc(+)" buttons simultaneously for about 1 second.)
3. Press " Enter " button, the adjusted value of your selected setting item stops blinking; now the
value of your selected setting item has been set.
4. Return to the initial screen by pressing "Exit" button twice.

4.5 Steering EXP "STEXP"

This function is used to change the sensitivity of the steering servo around the neutral and both
ends position. It has no effect on the maximum servo travel.
Adjust the sensitivity of direction wheel both in neutral position and ends.
Setup Item
RATE: Steering EXP
rate Adjustment range
-100%~0%~+100%
Initial value: 0%
0%~-100%: Sensitivity around neutral position is low,
getting higher when approaching ends.
0%: Sensitivity around the neutral and ends position is equal
0%~+100%: Sensitivity around neutral position is high, getting lower when approaching
ends
Throttle EPA
TH-FWD:0%~120%
TH-BRK:0%~120%
Initial value: 100%
Aux Servo EPA 4C-
UP:0%~120%
4C-DWN:0%
~120% Initial value:
100%
11