Advertisement
1 Standards and Adjustments
1.1 Electrical System (finisher/saddle unit)
1.1.1 Adjusting the Folding Position
The folding position is adjusted by matching it with the stapling position.
If you have replaced the finisher controller PCB, you must transfer the existing settings to
the new PCB. Perform the following if the folding position must be adjusted for some rea-
son.
Both the folding and stapling positions may deviate for some type of paper.
In such a case, change the "middle stapling position" in the user mode of
the host machine.
1) Set SW1 on the finisher controller PCB as follows:
COPYRIGHT © 2001 CANON INC.
Chap05.p65
ON
1
2
3
4
5
6
F05-101-02
2000 2000 2000 2000
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
1
CHAPTER 5 TROUBLESHOOTING
7
8
3/28/01, 12:11 PM
5-1
Advertisement
