Advertisement
CHAPTER 5 TROUBLESHOOTING
2) Adjust the folding position by pressing the PSW1 or PSW2 on the finisher controller
PCB a required number of times. Pressing the switch once moves the folding position
about 0.16 mm.
• To move the folding position in the "-" direction, press the PSW1.
• To move the folding position in the "+" direction, press the PSW2.
• Pressing the PSW1 and PSW2 at the same time clears the adjustment value.
3) When adjustment of the folding position is complete, set all bits of the SW1 on the fin-
isher controller PCB to OFF.
4) Enter the bind mode of the host machine and check whether the folding position is ad-
justed properly. If adjusted improperly, adjust the folding position again.
5-2
COPYRIGHT © 2001 CANON INC.
Chap05.p65
- direction
+ direction
F05-101-03
2000 2000 2000 2000
2
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
3/28/01, 12:11 PM
Advertisement
