Table of Contents
Advertisement
[8] ADJUSTMENTS
MX-LCX2
Each adjustment item in the adjustment item list is indicated with its JOB number. Perform the adjustment procedures in the sequence of Job
numbers from the smallest to the greatest.
However, there is no need to perform all the adjustment items. Perform only the necessary adjustments according to the need.
Unnecessary adjustments can be omitted. Even in this case, however, the sequence from the smallest to the greatest JOB number must be
observed.
If the above precaution should be neglected, the adjustment would not complete normally or a trouble may occur.
1. List
Job No.
ADJ 1
Print off-center adjustment
ADJ 2
Resist amount adjustment
2. Details
ADJ 1
Print off-center adjustment
1)
Execute SIM.50-10 by the key operation of the machine. Then,
the displays shown on the right side appear.
2)
The print off-center adjustment value can be set for each tray.
3)
Press the [↓] key on the touch panel to select "G:50:LCC".
4)
Then, enter your desired adjustment value with the [10] key.
(Default: 50
Adjustment range: from 1 to 99)
* If the adjustment value is decreased by 1, the main scanning
print position is shifted to the front side by 0.1mm.
* If the adjustment value is increased by 1, the main scanning
print position is shifted to the rear side by 0.1mm.
5)
When the [EXECUTE] button is pressed, the [EXECUTE] but-
ton is highlighted, currently set value is saved into the
EEPROM and the RAM, and printing for adjustment pattern
image is started. After printing is finished, the [EXECUTE] but-
ton returns to the normal display status.
6)
Check the adjustment pattern image position.
Measure the dimensions of the void area in the adjustment
pattern front and rear frame directions, and ensure that they
satisfy the conditions shown below.
If condition of A - B = 0±3.0mm is satisfied, no adjustment is
necessary.
If it does not satisfy the condition above, execute the proce-
dures shown below.
7)
Change the adjustment value. Repeat the steps from 4) to 6)
until the condition described in the step 6) is satisfied.
8)
After the adjustment is finished, escape from the simulation
mode with the reset key.
Adjustment item list
ADJ 2A
Change in the resist amount adjustment/deflection amount correction value
ADJ 2B
Adjustment of the print lead edge adjustment
A
+ -
A-B = 0
3.0mm
B
MX-LCX2 ADJUSTMENTS 8 – 1
Service Manual
[Switching of screen]
SIMULATION NO50-10
TEST
PAPER CENTER OFFSET SETUP
A 100
G:
50
B
50
C
50
D
50
E
50
F
50
G
50
H
50
I
1
J
2
K
1
10
Key
EXECUTE
SIMULATION NO50-10
TEST
PAPER CENTER OFFSET SETUP
A
100
G:
60
B
50
C
50
D
50
E
50
F
50
G
50
H
50
I
1
J
2
K
1
Simulation to
be used
50-10
51-02
50-05
0
CLOSE
BK-MAG
MFT
CS1
CS2
CS3
CS4
LCC
ADU
MULTICOUNT
PAPER CS1
DUPLEX NO
EXECUTE
OK
EXECUTE
Printing is finished
0
CLOSE
BK-MAG
MFT
CS1
CS2
CS3
CS4
LCC
ADU
MULTICOUNT
PAPER CS1
DUPLEX NO
EXECUTE
OK
Advertisement
Table of Contents
