CHAPTER 3 MECHANICAL SYSTEMS
1.2.2 Adjusting the Stapler Phase
When the gears or timing belt at the front of
the stapler is replaced or removed for some
reason, the staple shooting timing of the
staple driver (lower unit of the stapler) does
not match the staple bending timing of the
staple clincher (upper unit of the stapler).
Adjust the stapler phase following the pro-
cedure described below.
1) Detach the gear cover [2] from the staple
driver [1].
2) Remove the E-ring [3] to detach the side
cover [5] of the staple clincher [4].
3-8
COPYRIGHT © 2001 CANON INC.
Chap03.p65
[3]
[5]
2000 2000 2000 2000
8
Timing belt
Gear
F03-102-03
[2]
F03-102-04
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
3/28/01, 12:09 PM
Gear
[4]
[1]