Advertisement
<3>Install the front cabinet to the original position, push the staple unit
into the machine, and fix it with four fixing screws.
*
When installing, insert the projection (B) of the lock release lever into
the latch arm hole (C).
*
After installation, release the latch and move the lever to check that it
slides smoothly.
*
If it does not move smoothly, disengage the pawl on the lower side of
the release lever with a screwdriver (-) and remove the lever. Then
insert is again.
Staple unit
Fixing screw
Front cabinet
Fixing screw
<4>Install the jam process dial, and close the front cover.
Jam process dial
8) Install the right front cover of the finisher.
<1>Install the front cover with four fixing screws.
Front cover
Fixing screw
Pawl (D)
Latch arm
3
Lock release lever (A)
Projection (B)
Fixing screw
AR-FN7/PN1 UNPACKING AND INSTALLATION-6
<2>Install the stand cover with three fixing screws, and install the sub
cover with one fixing screw.
Fixing screw
Sub cover
Fixing screw
9) Attach the dust box label to the upper cover.
<1>Attach the dust box cover to the position shown in the figure below.
10) Connect the connector to the paper feed desk, and connect the AC
cord of the power unit to the printer.
<1>Connect the connector of the interface harness of the finisher to the
paper feed desk, and tighten the connector fixing screw.
<2>Connect the AC cord of the power unit to the inlet connector of the
printer as shown in the figure.
Connector
11) Turn on the main switch of the printer.
<1>Insert the power plug of the printer to the power outlet.
<2>Turn on the main switch of the printer.
Fixing screw
Stand cover
Fixing screw
AC cord
Fixing screw
"ON"
Advertisement
