Table of Contents
Advertisement
6
6-25 Using the Fiery XJ Print Calibrator
You can click Target to compare the target curve to the measured curve. The
N
:
OTE
closer the measured densities are to the target densities, the better the results you'll get
from calibration.
T
O EDIT THE TARGET CURVE
1. Click Target/Measured and Target on the right side of the dialog box.
2. Adjust the values in the Maximum Density areas for each color to adjust the endpoints
of the target curve as needed.
You can enter a value from 0.1 to 3.0.
:
Advertisement
Table of Contents
