Table of Contents
Advertisement
1
1-8 Operating the Fiery SI
If you press a button, the following options appear:
Choose:
Run Setup
Install Software
Format Disk
Restarting the Fiery SI
You should use the procedure described in this section to restart the Fiery SI rather
than using the power switch on the rear of the Fiery SI.
T
F
SI:
O RESTART THE
IERY
1. Make sure that the Fiery SI is not receiving, processing, or printing a document.
Make sure that the status message on the Control Panel is
If a job from the Print Queue is processing, it will continue processing and print
N
:
OTE
after the Fiery SI is restarted; if a job sent to the direct connection is processing, it will
not finish processing or printing.
2. Press the Menu button to display the Functions menu.
3. Use the down arrow button to scroll to the last screen and choose Reboot Server.
To do this:
View the options in the Setup menus. For information on
these settings, see the Administrator Guide.
Install new system software. This should be done only by
your Fiery SI service representative.
Reformat the Fiery SI hard disk. This should be done only
by your Fiery SI service representative.
Idle
.
Advertisement
Table of Contents
