PowerEdge XE7100 system overview
The PowerEdgeXE7100 is an ultradense 5U enclosure that supports up to two independent two-socket (2S) sleds and 100 x
3.5-inch drives. The PowerEdge XE7100 enclosure supports the following:
● Up to two server sleds and up to two expander modules
● Six rear accessible system fans
● Two 2400 W redundant power supply units
● Up to 16 DDR4 RDIMM/LRDIMM with maximum capacity up to 2048 GB per sled
● Up to 100 x 3.5-inch SAS or SATA drives
● Up to 8 x 7 mm SATA SSD (4 supported for NVMe SSD)
NOTE:
For more information about how to hot swap NVMe PCIe SSD U.2 device, see the Dell Express Flash NVMe
PCIe SSD User's Guide at https://www.dell.com/support> Browse all Products > Data Center Infrastructure >
Storage Adapters & Controllers > Dell PowerEdge Express Flash NVMe PCIe SSD > Documentation >
Manuals and Documents.
NOTE:
All instances of SAS, SATA drives are seen as drives in this document, unless specified otherwise.
For more information about supported drives, see the
Topics:
•
Supported configurations
•
Front view of the System
•
Front view of the control panel
•
Rear view of the system
•
Inside the enclosure
•
Locating the service Tag of your system
•
System information label
•
Rail sizing and rack compatibility matrix
Supported configurations
The PowerEdge XE7100 chassis is available in two versions:
● PowerEdge XE7100 chassis with two XE7420 sleds:
Drive specifications
section.
PowerEdge XE7100 system overview
2
7