Cleaning The Corotron Wires - Xerox DocuPrint 4512 Setup Manual

C l e a n i n g t h e P r i n t e r
Cleaning the
Corotron Wires
Power OFF the printer, disconnect the power
1
cord, and remove the corotron cleaner from its
slot.
7-10 D o c u P r i n t 4 5 1 2 / 4 5 1 2 N U s e r G u i d e
Cleaning the Autofeed Pickup Area
1 Power OFF the printer, disconnect the power cord, and remove the
Photoconductor / Drum and Toner Cartridge, following Steps 1
through 3 on page 7-3.
Wipe the interior surfaces of the printer.
2
The gears inside the printer are coated with grease and will
soil hands and cleaning cloths. Try to avoid touching these
gears.
Reassemble the printer and power it ON.
3
If the corotron wires become dirty, printouts may show streaks and
blotches. There are wires in the main corotron, located under the
Photoconductor / Drum, and in the transfer corotron, located inside the
top cover.
Cleaning the Main Corotron
Open the top cover by pulling up on the top
2
cover release lever and pivoting the cover
toward the front of the printer.