Cleaning The Printer; Cleaning The Exterior; Cleaning The Interior - Xerox VersaLink B600 User Manual

Cleaning the Printer

C L E A N I N G T H E E X T E R I O R
Clean the exterior of the printer once a month.
• Wipe the paper tray, output tray, control panel, and other parts with a damp, soft cloth.
• After cleaning, wipe with a dry, soft cloth.
• For stubborn stains, apply a small amount of mild detergent to the cloth and gently wipe the stain off.
C C a a u u t t i i o o n n : :
Do not spray detergent directly on the printer. Liquid detergent could enter the printer through
a gap and cause problems. Never use cleaning agents other than water or mild detergent.
C L E A N I N G T H E I N T E R I O R
W W a a r r n n i i n n g g : :
• Never touch a labeled area on or near the heat roller in the fuser. You can get burned. If a sheet of paper is
wrapped around the heat roller, do not try to remove it immediately. Power off the printer immediately and
wait 40 minutes for the fuser to cool. Try to remove the jam after the printer has cooled.
• If you spill any toner in the printer, remove the toner using a moist cloth. Never use a vacuum cleaner to remove
spilled toner. Sparks inside the vacuum cleaner can cause a fire or explosion.
To prevent stains inside the printer that can deteriorate print quality, clean the interior of the printer regularly. Clean
the printer interior whenever you replace the drum cartridge.
After clearing paper jams or replacing a toner cartridge, inspect the inside of the printer before closing the printer
covers and doors.
• Remove any remaining pieces of paper or debris. For more information, refer to
• Remove any dust with a dry, lint-free clean cloth.
Cleaning the LED Lens
1. Open the Front Door of the printer.
Xerox ® VersaLink ® B600/B610 Printer User Guide
Maintenance
Clearing Paper Jams.
133