Testing The Printer - Xerox DocuPrint 4512 Setup Manual

S e t t i n g U p t h e D o c u P r i n t 4 5 1 2 / 4 5 1 2 N
Testing the
Printer
12 S e t t i n g U p G u i d e
To test the printer, power it ON, then print a configuration sheet using
the Control Panel.
Power ON the printer and observe the following sequence on the
1
Control Panel:
The display reads
Self
The On Line light goes on.
The display reads
Emulation
where
Emulation
is the size of paper in the upper tray/lower tray.
Size/Size
Press On Line .
2
The On Line light goes off.
The display reads
Printing
Press Menu until:
3
The display reads
Test
4 Press Item until:
The display reads
Config.
5 Press Enter .
The Data light goes on and the Configuration Sheet prints.
If the Configuration Sheet does not print, refer to Chapter 6:
Troubleshooting in the DocuPrint 4512/4512N User Guide.
When the page finishes printing, the DATA light goes off.
6 Press On Line .
The On Line light goes on.
The display reads
Emulation
7 If you have purchased printer options, power off the printer, unplug
the power cord, and continue to "Installing Printer Options"
(page 13). Otherwise, skip to "Connecting to the Host" (page 14).
Test.
Size/Size.
is the emulation (PCL, PS2, Auto, HEX), and
Menu.
Menu.
Sheet.
Size/Size.