Table of Contents
Advertisement
Pivot the Photoconductor / Drum up toward
3
the front of the printer.
C h a p t e r 7 : P r i n t e r M a i n t e n a n c e a n d C o n s u m a b l e s
C l e a n i n g t h e P r i n t e r
Locate the main corotron's wire inside the slot
4
at the base of the raised Photoconductor /
Drum, and insert the cleaner's red brush into
one extreme end of the slot.
The tabs above the brush on the cleaner fit
into the groove above and parallel to the
slot in the Photoconductor / Drum.
Draw the cleaner all the way along the main
5
corotron to the other end of the slot, either to
the left or the right.
Go the complete width, from one side of
the Photoconductor / Drum to the
other. Do not take the cleaner out
halfway.
6
Return the corotron cleaner to its slot at the
rear of the printer.
7
Pivot the Photoconductor / Drum gently back
into place.
8
Close the top cover, reconnect the power cord,
and power ON the printer.
7-11
Advertisement
Chapters
Table of Contents
