Replacing The Photoconductor / Drum - Xerox DocuPrint 4512 Setup Manual

Network laser printer
Hide thumbs Also See for DocuPrint 4512:
Table of Contents

Advertisement

P r i n t e r M a i n t e n a n c e a n d C o n s u m a b l e s
Replacing the
Photo-
conductor /
Drum
Note
Caution
7-6
D o c u P r i n t 4 5 1 2 / 4 5 1 2 N U s e r G u i d e
The DocuPrint 4512's Photoconductor / Drum will print approximately
30,000 pages of A4 or 8.5 x 11 paper under average operating
conditions (5% image area coverage). The number of prints per
Photoconductor / Drum will decrease if you routinely:
Print dense text and graphics.
Adjust the Print Density to a dark setting.
Exceed five percent area coverage.
Replace the Photoconductor / Drum as soon as you see the following
message at the Control Panel display:
Drum Near End
The Supply indicator light will also glow.
Instructions begin on the next page.
See Appendix A: Ordering Information for ordering a new
Photoconductor / Drum.
Do not expose the Photoconductor / Drum to direct sunlight or
artificial light for more than 15 minutes. Overexposure will
permanently damage the photosensitive imaging drum.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docuprint 4512n

Table of Contents