E) With Voltage Controlled Servo Valve; Trim Electronics - Yamaha Enduro 8 Manual

E) with voltage con-
trolled servo valve
The output signal is suitable for proportion-
al valves with up to 20% hysteresis (e.g Dan-
foss Type PVEM).
Autopilot Com-
(DRIVEBOX)
Jumper 1 Jumper 2 Jumper 3
open closed
Jumper 4
closed
1 2 3 4 5 6 7 8
Battery leads:
2
2 x 0.5 mm
(AWG20)
Jumper 1 may be closed to reverse the
measured rudder angle; but the easier way is
altering A0 in the AP setup menu
puter
closed
Rudd. CAN-Bus AUX-1 AUX-2
Angle + NMEA
Battery
12 to 24 V
UDC
Output Signal: UDC/2
+/- 25%UDC (output
impedance = 1kOhm)
Set A5=08, A5*=01,
A0*=01; use A4*=0/1
for inverse signal; use
A1=0/1 to adjust idle
signal by 1% up
Rudder Angle
Sensor
Trim Flap Electronics
With switch over valve
Trim Computer
(TRIM BOX)
Jumper 1
Jumper 2 Jumper 3
open open
Jumper 4
open
2 3 4 5 6 7 8
up down up
Valve left
Valve
flap
right flap
Jumper
left
left flap angle
sensor
42
open
Flap
CAN CAN
Angle
Bus Bus
Battery
12 or 24V
Battery leads:
2
2 x 2.5 mm
down
Jumper
right
right flap angle
sensor