Trim Flap Function - Yamaha Enduro 8 Manual

Trim Flap Function

Mode Activa- Analogue LED pointer
tion
for Flap Angle
Mode Pre Selection
Pre select a desired mode with the SE-
LECT-button and activate it with the ENTER-
button.
Manual Split Mode
can be moved indepen-
dently with the up and
down arrow buttons.
angle limit (t6: and t7:) are
not valid in this mode.
Manual "both"-
Mode
mode.
The LCD is
blinking,
when a new
mode has
been pre se-
lected, but
not yet acti-
vated with
the ENTER-
button
The left and right flap
This mode works
also in the case of a
defective flap angle
sensor. The flap posi-
tion must then be
checked visually,
since there would be
no display of it.
Upper and lower flap
The selected flap
angle will be automati-
cally maintained by
both flaps.
The upper and
lower flap angle limits
(t6: and t7:) will be
observed in this
stay dark.
Warnings
working below 9 Volts.
24
OFF-Mode
The TRIMBOX will
be in OFF-mode
initially, when power
is turned on.
If the trim box is
not powered or not
connected to the
bus, the LCD will
also show OFF and
the flap angle LED's will
Low Battery
Alarm
The battery alert
comes on when the
supply voltage has
dropped below 10
Volts. It disappears
only after voltage has
increased above 11
Volts. The display stops