Connectors, Plugs And Cables - Yamaha Enduro 8 Manual

Connectors, Plugs and Cables

Bus cable
Standard version: RJ45 plug
The white lead of the four lead flat cable
goes to the left side of the plug (contact nr. 1)
and the remaining leads are placed to the
adjacent contacts 2,3,4.
Contacts 5,6,7,8 must re-
main free. Attention must
be paid to the situation of
Contact Nr.1
white lead
"Western" Plug
-- For Alternate Bus version (8 lead)
-- For Compass Sensor (8 lead)
-- For NMEA in-/out (8 lead)
-- For Log Sensor (6 lead)
-- For Wind Sensor (6 lead)
-- For Heading Gyro (6 lead)
Plug Installation:
1. Remove the cable's jacket.
Round
cable
~15 mm
2. Insert cable into lid and fix it there.
the plug as depicted,
to avoid inter-
changing
contacts 1
and 8.
white
lead
Flat
cable
white lead to
nr. 1
48
3. Use the diagrams below for proper
matching of color- to-contact:
8
7 6
5 4
3
2 1
Bus cable: 8-pin plug, 4-wire cable
Pin round flat
# cable cable
1 white white
2 brown blue
3 yellow cyan
4 green magenta
5,6,7 and 8 must remain unconnected
Wind & Compass Sensor and Echo-Box:
8-pin plug:
Flux Gate Echobox
HS8000 -1 or -2
RJ45 round flat
pin# cable cable
1 red (white) white
2 green (brwn) blue
3 cyan
4 (jumper 2-7 magenta
5 inside RJ45) white
6 blue (yello.) orange
7 brown
8 yellow (grn.) red
Note: leads 3 and 4 are the CAN-bus sig-
nals. They must not be connected to a sensor
or to the Echo-Box.
red
yellow
1
4
green
2 blue
3
Log and Wind Sensor, Sonic Heading
Gyro, Roll and Pitch Angle Sensor, Mast
Angle Sensor:
6 pin plug, 4-wire cable:
pin round flat-oval
# cable cable
2 white white
3 brown blue
4 yellow cyan
5 green magenta
pin 1 and 6 must remain unconnected
PB100 Wind-
Sensor
6-lead 4-lead RJ45
cable cable pin#
red white
black brown
(jmpr 2-
7 inside
orange RJ45)
yellow yellow
blue
white green
HS8000: Sensor
Cable Connector, as
seen from the cable
side
1
2
3
4
5
6
7
8