Compass Display Function - Yamaha Enduro 8 Manual

Compass Display Function

Not valid for
Analogue LED-pointer
six-button Auto-
for the selected heading
pilot Displays
(upper face of display).
Digital display
(LCD)
Decimal
Symbol for
Heading
Gyro oper-
ation (ap-
pears 5 min-
utes after power-
up of the gyro).
Second LED-pointer for rudder
angle (lower face of display)
Selected Heading
ments of the selected
heading, the left or right
button may be pressed and held.
After a few seconds of button-inactivity, the
actual heading will come up again.
Heading Hold
The LCD shows
the actual heading,
the LED-pointer
points onto the se-
lected heading (ex-
panded scale).
The Gyro Symbol
- the decimal behind
the H - eshould be
monitored, when
using the autopilot.
The selected heading
is displayed after
pressing briefly either
arrow button. With
every following button
application, the se-
lected heading will be
modified by one de-
gree. For larger adjust-
(Valid only for a three button display unit.
For an Autopilot Display see page 20)
only available if during
configuration "di" was set
to 02.
button (middle button) for
selected heading.
(di=00), not on a Com-
pass- Autopilot- Display, with di=02.
6
Engaging the
Autopilot
The autopilot function is
Press and hold the AP-
two seconds. When the
autopilot is engaged,
the mode display
shows briefly the
autopilot number (1
or 2) and then the
selected heading.
Initially the actual
heading is stored as
Disengaging the
Autopilot
This autopilot
function is only avail-
able if during config-
uration "di" was set
to 02.
Press the AP-
button briefly to dis-
engage the autopilot
immediately. The
OFF-alert will come
on. It may be cleared
by briefly pressing any
of the three buttons.
Magnetic Heading
The actual heading
is displayed. No LED-
pointer for the select-
ed heading).
This function is
only available on a
Multi Function Display