Jumbo Display Functions - Yamaha Enduro 8 Manual

Jumbo Display:
Function
Left
View with lid removed
Jumper
Middle
Jumper
Right
Jumper
The lid has to be removed
Display
for accessing the switch
Selector
The following functions are available when
the jumpers (above) are left open:
Display
Selector
> > > > >
SPD SPD SPD SPD SPD
1
Boat Speed in 0,1 kts.
HdG HdG > > > > >
HdG HdG HdG
2
Compass Heading in Degrees.
t r u t r u t r u t r u t r u > > > > >
3
True Wind Speed in 0,1 kts.
t r u t r u
t r u t r u t r u > > > > >
4
True Wind Angle (+/- 180 degrees)
> > > > >
d i r d i r d i r d i r d i r
5
Wind Direction (degrees magnetic)
> > > > >
APP APP APP APP APP
6
Apparent Wind Speed in 0,1 kts.
APP APP > > > > >
APP APP APP
7
Apparent Wind Angle (+/- 180 degrees)
> > > > >
vMG vMG vMG vMG vMG
8
VMG in 0,1 kts.
Eco Eco > > > > >
Eco Eco Eco
9
Depth in 0,1 m or 0,1 ft (unit selec-
tion on Multi Function Display)
5.7 5.7 5.7
5.7 5.7
335 335 335 335 335
2 2 2 2 2 0.5 0.5 0.5
0.5 0.5
12 120 0 0 0 0 12
12 12
275 275 275
275 275
15.4 15.4 15.4 15.4 15.4
- 35 - 35
- 35 - 35 - 35
H H H H H 7.5 7.5 7.5 7.5
7.5
4.9 4.9 4.9 4.9 4.9
Display
Selector
c o n c o n c o n c o n c o n
0
The JUMBO Display works simi-
lar to a Multi Function Display when
the Display Selector is in position
zero. Use the jumpers in the same
way as the push buttons on the Multi
Function Display.
Leave the jumper open, if the
button is not to be pressed (or set
the jumper only onto one of the two
pins).
The first active function will be
displayed after power on.
If the configuration is to be
changed, use the jumpers in the
same way as the push buttons on a
Multi Function Display.
Note: after turning on power to the JUMBO
Display, it takes 30 seconds before the digits
start working.
Illumination
button first, then the others.
3. Adjust brightness with left or right button.
All other displays with the same group
number will follow in brightness.
4. Exit from the function with the SELECT-
button.
16
> > > > > F i G F i G F i G F i G F i G
If you have a dimmer
installed in the system,
use it. Otherwise use
the push buttons of a
Multi Function Display
for illumination control.
This display must be
set to the same Dis-
play Group Number
as the Jumbo Display:
1. Press and hold
all three buttons.
2. Release SELECT