Warnings; Set Up - Yamaha Enduro 8 Manual

Secondary Functions:
The Secondary Display Functions can be
accessed by holding the SELECT button for
two seconds for the first function and then
briefly pressing it for all other functions.
After the last Secondary Function follows
again the first Primary Display Function.

Warnings

Low Battery Alarm
LCD blinking
Magnetic Wind
This function re-
quires a heading
sensor in the system.
The magnetic
wind direction or true
wind speed can be
selected alternately
with the right button.
The analogue
LED shows the rela-
tive angle of the true
wind.
VMG
This is the part of
the boat speed in
direction of the true
wind vector, either
upwind or downwind.
The analogue LED
shows the relative
true wind angle.
The battery alert
comes on when the
supply voltage has
dropped below 10
Volts. It disappears
only after voltage has
increased above 11
Volts. The display
stops working below
9 Volts.
Sensor Warning
Dashes on the LCD are
wind sensor physically
connected is SE=06 or 07 (or n0=00 for the
PB100/200 wind sensor).
Settings
Tecnautic Wind Vane Correction
The wind angle can be corrected by alter-
ing the correction "C".
1. Select the wind function, then press both
arrow buttons briefly at the same time.
2. Use the right button to increase a star-
board wind angle or to decrease a port wind
angle.
Use the left button to increase a port wind
angle or to decrease a starboard wind angle.
3. Exit the function with the middle button.
PB100/200 Wind Sensor
The compass alignment of the PB100/200
will also align the wind angle.
Illumination
If you have a dimmer installed in the sys-
tem, use only the dimmer.
with left or right button.
All other displays with the same group
number will follow in brightness.
4. Exit from the function with the SELECT-
button.
11
an indication that valid
signals are not re-
ceived from the sen-
sor (or the wind vane
sits at zero degrees
for a prolonged peri-
od). Check also, that
the configuration of
the display with the
This correction
has to be done at a
display unit with the
wind sensor physi-
cally connected and
the sensor type
number correctly
configured and the
apparent wind func-
tion displayed.
Otherwise use the
push buttons for illu-
mination control:
1. Press and hold
all three buttons.
2. Release
SELECT button first,
then the others.
3. Adjust brightness