Table of Contents
Advertisement
Log Function
expanded analogue LED
pointer (once round per
Primary Functions:
Primary Display Functions are selected in
sequence by briefly pressing the SELECT
button.
Boat Speed
Actual water speed in
knots. Replaced by GPS-
Speed in case there is no
Log Sensor in the system.
The analog LED pointer
is expanded to once
round per knot.
the configuration menu.
Trip Distance
tered up to 999,9 NM. It
can be cleared with the
left button or it is cleared
automatically, when
TRIP TIME starts ei-
various displays.
knot)
Digital LCD
If desired, the
LED can be config-
ured OFF and the
speed averaged
over 15 seconds by
selecting dF=24
instead od dF=20 in
Trip distance is regis-
ther manually or after
the race timer has
counted down to
zero.
Trip distance is a
local function and
may be running
independently on
Secondary Functions:
The Secondary Display Functions can be
accessed by holding the SELECT button for
two seconds for the first function and then
briefly pressing it for all other functions.
After the last Secondary Function follows
again the first Primary Display Function.
Trip Time
following Function:
2
Temperature
Water Tempera-
ture is sensed at the
Log Sensor.
Dashes are dis-
played in case of an
open sensor circuit
(eventually verify
correct Sensor Type
SE=.. in the display
configuration).
The left button has the
Stop, Reset, set minus
5 or minus 10 minutes.
The timer is started
with the right button.
The Display shows
minutes and sec-
onds (up to one
hour) and hours and
minutes (for more
than one hour).
Trip Time is a local
Function.
Average Speed
Average Speed is
calculated from TRIP
TIME and TRIP DIS-
TANCE.
Average speed is
not calculated, when
the timer is halted
(display = zero).
Average Speed is
a local function and
may be different on
every Display unit.
Advertisement
Table of Contents
