Table of Contents
Advertisement
Display Configuration
applicable for displays with three or
six push buttons
Note: you might not find all of the following
possibilities on a display or you might even
see additional functions on some displays.
Attention: During configuration, the dis-
play will not transmit data from a connected
sensor.
(lower) button to scroll
through the ConFig menu:
Display Test
Sensor Type Selection
Display Type Selection
Display Function Selec-
Display Group Selection
Autopilot Configuration
(or Trim Flaps if di=03).
It is not available if di=00.
NMEA in- and output
Sensor type Selection:
Every display has an "an-
alogue" sensor input (yellow/
green marking).
Use left and right (lower)
button for selection of
ConFig menu:
1. Press and hold
both outer (lower)
buttons.
2. Without releas-
ing the outer buttons,
apply the middle
(lower) button four
times briefly.
3. Then release
the outer buttons. The
"Con-Fig" mode will
appear on the LCD.
4. Use the middle
tion
26
the type of the connected sensor, according
table below.
For "Digital" Sensors, which are connected
to the NMEA in- and output (red marking), like
a Magnetic Compass, a Depth Sounder or
a GPS, the NMEA in- and output has to be
configured (see p.28).
Any sensor may be connected to any dis-
play. E.g. a wind sensor may be connected to
a display with "COMPASS" imprinting, if SE:06
has been selected.
00 No Sensor connected
01 One single Log Sensor
02 left Log Sensor (with Mixer)
03 right Log Sensor (with Mixer)
04 left alternating Log Sensor
05 right alternating Log Sensor
06 Standard Wind Sensor
07 Wind Sensor for rotating mast
08 Mast Angle Sensor for rotating mast
09 Heading Gyro: align by GPS track only
10 Heading Gyro: align a) GPS or b) Fluxg.
11 Heading Gyro: align by Fluxgate only
12 Heading Gyro: align a) Fluxg. or b) GPS
13 Roll Gyro
14 Rig Load Sensor
17 AP+depth Alarm and Display Dimmer
18 Depth Alarm and Display Dimmer
19 external rudder sensor for AP1
20 external rudder sensor for AP2
21 Servo Wheel: autom. selection;only di=1
22 Servo Wheel: manual select.; only di=1
23 Servo Wheel: manual select.; only di=1
Note: If no Sensor has been con-
nected, SE must be set to zero.
If SE:xx comes on automatically or the
function cannot be exited even by switching
power off and on, we have a Sensor Conflict
Warning. Every display on the bus could be
the reason and has to be checked for the cor-
rect "SE"-number. Only one SE=06 is allowed!
Display Type Selection:
Advertisement
Table of Contents
