Settings And Warnings - Yamaha Enduro 8 Manual

Secondary Functions:
The Secondary Display Functions can be
accessed by holding the SELECT button for
two seconds for the first secondary function,
and then briefly pressing it for all other func-
tions.
ary Function follows again
the first Primary Display
Function.
Sensor-Frequency
Only with Echo-Box-2
and only on the Display
Unit set to n0=05 (and to
which the Echo-Box2 is
lected with the left or
right button. Set the same
number as marked on the
transducer cable (Important for good trans-
ducer function!)
Settings:
Depth offset to keel or surface
1. Select depth display
of "c" will be added to
the sensed depth (used for
depth below surface indication), a negative "c"
will be subtracted from the sensed depth
(used for depth below keel).
To alter the correction, press left or right
button repeatedly.
Exit this function with the middle button.
After the last Second-
Depth Units
The left or right
button is used to se-
lect the desired units
(meters or feet).
physiclly connected).
This function fol-
lows in sequence
after the Depth Units
function above.
The transducer
frequency can be se-
2. Press and hold
both arrow buttons for
two seconds.
With a zero correc-
tion setting (c 0.0),
depth is measured
from the sensor loca-
tion. A positive value
Illumination
If you have a dimmer installed in the sys-
button.
All other displays with the same group
number will follow in brightness.
4. Exit from the function with the SELECT-
button.
Warnings:
hull installation).
If the Echo-Box does not communicate with
the display, there will also be dashes on the
LCD. Check the correct configuration of the
display with the Echo-Box physically connect-
ed (n0:04 for Echo-Box-1 or n0:05 for Echo-
Box-2 in the NMEA setup).
Volts.
13
tem, use only the dim-
mer. Otherwise use the
push buttons for illumi-
nation control:
1. Press and hold
all three buttons.
2. Release
SELECT button first,
then the others.
3. Adjust bright-
ness with left or right
Dashes on the
display:
means no echo
received. The reason
could be depth ex-
ceeding the range or
excessive sound ab-
sorption in the water,
at the bottom (or in the
hull in case of a within
Low Battery Alarm
The battery alert
comes on when the
supply voltage has
dropped below 10
Volts. It disappears
only after voltage has
increased above 11
Volts. The display
stops working below 9