Landoll Brillion P Series Operator's Manual page 15

6. If the wheel gang has female hardware, slide the
wheel gang end-wise, toward the center bracket,
mating the square bore bearing with the stub shaft on
the center bracket.
Figure 2-5: Wheel and Axle Installation - 2 of 4
Figure 2-6: Wheel and Axle Installation - 3 of 4
7. Install right hand end plate assembly on the center
frame tube: use 5/8-11 x 5 1/2" deep x 6 11/16"
center U-bolt, 5/8" Washers and Nuts on angle
8J099, and 1/2-13 x 7 1/2" deep x 4 1/2" center
U-bolts with 1/2" Lockwashers and Nuts on angle
8J100. See Figure 2-6. While installing, be sure to
mate the bearing with the end plate stub shaft.
ASSEMBLY
2-5