Notes About This Documentation; Validity Of This Documentation; Table 1: Variants - WAGO 750-469 Manual

WAGO-I/O-SYSTEM 750
750-469 2AI Thermocouple
1

Notes about this Documentation

Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation is
included, if necessary.
1.1

Validity of this Documentation

This documentation is only applicable to the I/O module 750-469
(2AI Thermocouple) and the variants listed in the table below.

Table 1: Variants

Item Number/Variant
750-469
750-469/000-001
750-469/000-002
750-469/000-003
750-469/000-006
750-469/000-008
750-469/000-012
750-469/000-200
750-469/000-206
750-469/003-000
Documentation Validity for Variants
Unless otherwise indicated, the information given in this documentation applies to
listed variants.
The I/O module 750-469 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus
coupler/controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler/controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
Manual
Version 1.1.0
Notes about this Documentation
Designation
2AI Thermocouple/K/Diagn.
2AI Thermocouple/S/Diagn.
2AI Thermocouple/T/Diagnose
2AI ±120mV Diagn.
2AI Thermocouple/J/Diagn.
2AI Thermocouple/E/Diagn.
2AI Thermocouple/L/Diagn.
2AI Thermocouple/K/Diagn./S5
2AI Thermocouple/J/Diagn./S5
2AI Thermocouple/Free Config.
*)
*)
*)
Data format for S5 control with FB 250
5