Device Description - WAGO 750-606 Manual

WAGO-I/O-SYSTEM 750
750-606 24 V DC 1.0 A power supply Ex i
3

Device Description

The I/O module 750-606 (24 V DC 1.0 A power supply Ex i) provides 24 VDC
power to the 750 Series.
Furthermore, it separates the intrinsically safe part from the non-intrinsically safe
part of the fieldbus node and makes diagnostic information available in the
process image.
Installation only in zone 2 or in non-hazardous environments!
The installation of the WAGO-I/O-SYSTEM 750 fieldbus couplers/controllers and
I/O modules is only to be done in zone 2 or in non-hazardous environments.
One green status LED indicates the status of the input voltage and one green/red
status LED indicates the status of the output voltage.
The meaning of the LEDs is described in the "Display Elements" section.
The supply module receives the 24 V voltage supply for the field level from an
external source via the CAGE CLAMP
subsequent I/O modules via the power contacts used as spring contacts.
Do not exceed maximum current via power contacts!
The maximum current available from the 750-606 Ex-i Supply Module is
1000 mA.
Greater currents can damage the power contacts.
When configuring the system, ensure that this current is not exceeded.
If exceeded, an additional potential feed module must be used.
Input and output voltages of the supply module are electrically isolated from each
other.
The 750-606 module can be used with the fieldbus couplers and controllers of
the WAGO-I/O-SYSTEM 750 of the specified version or higher listed in the
"Compatibility list" table.
Device Description
®
connectors and provides this potential to
Version 1.4.0 valid from HW version 03
13
Manual