Adjustment Of The Wiper; Draining Waste Oil; Amount Of Oil Supplied To The Hook - Texi Catenaccio Operation Manual

TEXI Catenaccio operation manual

6. Adjustment of the wiper

7. Draining waste oil

8. Amount of oil supplied to the hook

1. The state of standard delivery is the position where (3) is lightly screwed in and returned by 4 turns.
2. When reducing the amount of oil, do not screw in the screw at once.Observe the state for approxima-
tely half a day at the position where (3) is screwed in and returned by 2 turns. If reducing is excessive,
worn-out of the hook will result.
Turn OFF the power before starting the work so as to prevent accidents cause by
abrupt start of the sewing machine.
Loosen screw (1) to adjust so that a clearance of 1.5
mm or more is provided between the wiper and the
needle.
At this time, the standard of the distance between the
wiper and the needle is 23 to 25 mm. By adjusting
the distance wide, the work clamp foot can prevent
stepping on needle thread when it comes down.
Especially when the thin needle is used, adjust the
distance wide to such an extent of 23 mm.
The position of the needle is when the sewing machine
has stopped after the sewing finished.
When polyethylene oiler (1) becomes filled with oil,
remove polyethylene oiler (1) and drain the oil.
1. Loosen setscrew (1) and remove setscrew (1).
2. When screwing in adjustment screw (2), the amount
of oil of oil pipe, left (4) can be reduced.
3. After the adjustment, screw in setscrew (1) and fix it.
43