TEXI Catenaccio operation manual
2. Attaching the needle
3. Threading the machine head
Pull out the thread by approximately 4cm from the needle after threading through the needle.
1.When the silicon oil is used, thread through thread guide for silicon (1)
2.For thick thread, pass the thread through one hole only of needle bar thread guide (2)
Turn of the power before starting the work so as to prevent accidents caused by
abrupt start of the sewing machine
Turn of the power before starting the work so as to prevent accidents caused by
abrupt start of the sewing machine
Loosen setscrew (1) and hold needle (2) with the long
groove facing toward you.Then fully insert it into the hole
in the needle bar, and tighten setscrew (1).
If the stitches are made as shown in "A",
attach the needle facing to the direction B"
to a small extent.
13