Input Signal Test - Texi Catenaccio Operation Manual

TEXI Catenaccio operation manual
Function Test Code
11-1. CP-1 Input Signal Test
Test the input status of the buttons, pedal and sensors. Press
the screen. After that, the screen displays the "1" that means the first test content.
Hint: if press P1& P2 at the same time when you input number, the
inputted number will add 1 and renewed.
Function
Test input signal
X/ Y Motor Origin Sensor
Test
Continuous Running
Main motor rotation num-
ber test
Thread-trimming test
Presser /thread-trimming
motor /origin sensor test
Thread-catching motor/
origin sensor test
_________________
Content
LED hint switch, sensor input
Display the statuses of the X/Y motor step motion
operation, origin searching operation and X/Y
origin sensor.
If setting the condition of continuous running, test
the continuous running mode.
Setting rotation number, machine start-up ,display
of actual rotation number
Action of thread-trimming motor, debugging the
installation of knife
Display the step motion of presser/thread-trimming
motors, operation of origin searching, and the
status of presser origin/presser sensor.
Display the step motion of thread-catching motor,
operation of origin searching and the status of
thread-catching origin/thread-catching sensor.
_________________
to have access to CP-1 when the "CP-1" is displayed at
Hint: for the input status hint information
of Sewing LED at ON/OFF, please refer to
the below table.
27