Safety Switch; Tilting The Sewing Machine Head; Installing The Operation Panel - Texi Catenaccio Operation Manual

TEXI Catenaccio operation manual

7. Safety switch

Cut off the safety switches cable ties which be fixed under the machine , safety switches will be installed in the machine
as shown here, with screw lock, overturning the head, checking the suitability of the safety switch mounting position, heads
up is required, Table board to open the safety switch top picks, picks of safety switches and safety switches do not touch,
otherwise the error E302.
1. If you do not remove the safety switch, and installed in the correct position, machine will can't sewing;
2. Safety switches installed, if happen error E302, please adjust the security switch down, to ensure
the safety switch picks with the table adequate contacts.

8. Tilting the sewing machine head

9. Installing the operation panel

Use four wood screws (1) fix the operator panel (2) on the table (3) in a comfortable operation position, then the operator
panel (2) corresponding wire hole through the table (3), and then dock with the other side.
Turn head (1) gently down , and leaning the head on
the head supporting bar at (2).
1. Before tilting the sewing machine head,
make sure that head support rod (1) is
attached to the machine table;
2. When raising the sewing machine head,
do not raise it while holding motor cover
(2).It will be the cause of breakage of motor
cover (2).
3. Be sure to tilt the sewing machine head on
a flat place to prevent it from falling.
10