Standard Adjustment; Adjusting Thread Guide; Adjusting The Needle Bar Height - Texi ART AUTO User Manual

9. Standard adjustment

Maintenance and inspection of the sewing machine
should only be carried out by a qualified technician
All work connected with electrical installation must be
done only by qualified electrician.
Do not modify by yourself any part of the machine. If any
safety devices have been removed, be absolutely sure to
re-install them to their origin positions and check that they
operate correctly before using the machine.

9.1 Adjusting thread guide

9.2 Adjusting the needle bar height

EN TEXI ART AUTO operation manual
CAUTION
Secure the table so that it will not move when tilting
back the machine head.
Use both hand when tilting back the machine head
During maintenance and inspection machine must
be turned off and disconnected from the power
supply.
The standard position of arm thread guide R (1) is the position
where the screw (2) is in the center of the adjustable range for
arm thread guide R (1). To adjust the position, loosen the screw
(2) and then move arm thread guide R (1).
•
When sewing thick material, move arm thread guide R (1)
to the left. The thread take-up amount will become greater.
•
When sewing thin material, move arm thread guide R (1)
to the right. The thread take-up amount will become less.
Reference line (a), which is the second line from the bottom of the
needle bar (1) should be aligned with the lower edge of the nee-
dle bar bush D (2) as shown in the illustration when the needle
bar (1) is at its lowest position.
1. Turn the machine pulley to set the needle bar (1) to its lowest
position.
2. Remove the cap (3) from front cover.
3. Loosen the screw (4) and then move the needle bar (1) up or
down to adjust its position.
4. Securely tighten the screw (4).
5. Replace the cap (3)
40