Checking The Contour Of A Sewing Pattern; Sewing - Texi Catenaccio Operation Manual

TEXI Catenaccio operation manual
When turning OFF the power without pressing
of max. rotation, and thread tension are not memorized.
2. Confirmation of Pattern Shape
After selecting the pattern, user shall confirm the shape of the pattern.
If the pattern is far away from the presser, the needle will run into the presser, thus breaks the needle.
The work clamp feet do not come down immediately after turning ON the power.

3. Sewing

key, the set values of pattern No., X/Y scale, number
1. Press to light up the Sewing LED
2. Press to select
displays
presser and then the screen displays
3. In the status of lowering the presser, press
4. Use and
The confirmed pattern for sewing shall be in the permitted
range of the presser.
5. Press to lift presser.
6. Press to release the selection of
other data item other than
to end the trial sewing and Sewing LED will be off.
1. Put the fabric to the presser section
2. Step on the pedal switch to the level 1, then the presser
goes down. If you detach the foot from the pedal,
the presser will go up.
3. Lower the presser to the next level, and then depress
the pedal to the second level to start sewing
4. At sewing end, the presser will go up and stop at the initial
position.
, and then the screen
; step the pedal to lower the
.
to confirm the shape.
(select
). After that, press
17