Functionality Testing - AJAX LeaksProtect User Manual

Functionality Testing

The Ajax security system allows conducting tests for checking the
functionality of connected devices.
The tests do not start straight away but within a period of 36 seconds when
using the standard settings. The test time start depends on the settings of
the detector scanning period (the paragraph on "Jeweller" settings in hub
settings).
Signal Strength Test
Attenuation Test
Selection of the Detector Location
Location of the detector determines its remoteness from the hub (up to
1300 meters) and absence of any obstacles between the devices hindering
the radio signal transmission: walls, inserted floors, large-size objects
located within the room.
Check the signal level at the installation location
If the signal level is one division, we cannot guarantee stable operation of
the security system. Take possible measures to improve the quality of the
signal! As a minimum, move the device – even 20 cm shift can significantly
improve the quality of reception.
If, after moving, the device still has a low or unstable signal strength, use a
radio signal range extender ReX.
The sensor should be placed in the place of probable water leakage from
the water supply, heating, sewage systems: on the floor under the
bathroom, under the washbasin, under the washing machine, etc.
Do not install the detector:
outside the premises (outdoors);
