AJAX LeaksProtect User Manual page 4

Request for connection to the hub is transmitted for a short time at the time
of switching on the device.
If the connection to the hub failed LeaksProtect will switch off after 6
seconds. To retry the connection, you do not need to turn off the device. If
LeaksProtect was already assigned to another hub, switch it off, then
perform the standard adding procedure.
The detector connected to the hub will appear in the list of devices of the
hub in the application. Update of the detector statuses in the list depends
on the device inquiry time set in the hub settings, with the default value –
36 seconds.
Connecting the Detector to Third Party Security Systems
To connect the detector to a third party security central unit using
the or integration module, follow the
uartBridge ocBridge Plus
recommendations in the manual of the respective device.
The detector always operates in the active mode. When connecting
LeaksProtect to third-party security systems, it is appropriate to place the
detector in a permanently active protection zone.