Scraper Kit (Optional)
(Cannot be used with Coil Tine Track Remover Kit)
See Figure 2-23.
1. Assemble 1K212 brackets to front of seeder frame
tube. The brackets are provided. (If you have a wheel
track remover kit on your seeder you will not need
these brackets on the outer ends). You can mount to
the same brackets provided with the wheel track
remover. Do not fasten securely at this time.
2. Attach vertical brackets loosely and assemble
scraper angle to them. Attach two center scrapers at
center hole locations and then attach all of the
regular scrapers. Center entire assembly on
machine, position scrapers for proper fit and tighten
hardware.
3. Scrapers should be close enough to the wheels to be
functional but without interference. Some final
adjustments maybe required in the field.
Figure 2-23: Scraper Kit
ASSEMBLY INSTRUCTIONS
2-21