Troubleshooting - Gira System 3000 Operating Instructions Manual
Presence and motion detector 360 top unit bt
Hide thumbs
Also See for System 3000:
- Operating instructions manual (25 pages) ,
- User manual (10 pages) ,
- Operating instructions (3 pages)
Table of Contents
Advertisement
System 3000
Presence and motion detector 360° top unit BT
Parameters
Setting options,
default setting
Default setting:
Do not use func-
tion
Adjusting basic
5 ... 100%
brightness
Default setting:
20 %
Setting the night
5 ... 100%
light
Default setting:
20 %
Activating the
On, Off
constant light
regulation
Default setting:
Off
Setting the bright-
5 ... 1000 lx
ness value
Default setting:
600 lx
Using the current
Measures the
brightness
current bright-
ness value.
9
Troubleshooting
Device does not switch on
Cause 1: The ambient brightness is greater than the adjusted brightness threshold.
Set the brightness value with the app.
Cause 2: Device does not detect any motions.
Increase sensitivity with the app.
Switch on all sensors with the app.
Cause 3: Timer OFF or Continuous OFF is activated.
Activate the automatic mode with the app.
Device switches on without motions
Cause 1: Presence simulation is activated. Device switches at saved times.
Switch off the presence simulation with the app.
Cause 2: Interference sources in the detection area.
Remove interference sources if possible.
Reduce sensitivity with the app.
Limit the detection field with the app.
Device switches off despite motion
Cause 1: The device does not detect any motion.
Increase sensitivity with the app.
Cause 2: Detection area is limited because a sensor was switched off.
Switch on all sensors with the app.
82599322
Explanation
Night light:
When the function is activated, the light is not switched
on to the switch-on brightness but to a defined bright-
ness value when motion is detected.
Determines the brightness of the basic brightness func-
tion.
Determines the brightness of the night light function.
The motion detector determines the brightness value
from artificial light and daylight. This value is kept con-
stant at the set brightness level.
Value at which the light is kept constant.
Applies the currently measured brightness as the bright-
ness value for the constant light regulation.
24.10.2019
12 / 13
Advertisement
Table of Contents
