Gira System 3000 Operating Instructions Manual page 11

System 3000
Presence and motion detector 360° top unit BT
Parameters Setting options,
default setting
Pulse operation On, Off
Default setting:
Off
Delay output 2 Activating switch-
on delay
Only for 2-gang On, Off
switch insert Switch-on delay
0 s ... 60 min
Switch-off delay
0 s ... 60 min
Default setting:
Activating the
switch-on delay
ON, switch-on
delay 2 minutes,
switch-on delay
5 minutes
Settings only for dimming inserts
Parameters Setting options,
default setting
Switch-off pre- On, Off
warning
Default setting:
Off
Switch-on bright- 5 ... 100 %
ness
Default setting:
100%
Maximum dim- 1 ... 100%
ming value
Default setting:
100 %
Minimum dim- 1 ... 67%
ming value
Default setting:
100 %
Night light/basic Do not use func-
brightness tion
Use basic bright-
ness
Use night light
82599322
Explanation
on time is thereby prolonged by approx. 30 seconds. If
motion is detected during the switch-off pre-warning,
then the run-on time is restarted and the light remains
on.
If motion occurs, then a short pulse of approx. 0.5
seconds is triggered depending on the brightness. The
pulse is repeated approx. every 3 seconds as long as
motions are detected.
Activating the switch-on delay:
Activating or deactivating the switch-on delay for output
2
Switch-on delay:
Time to switch on output 2 with a delay when the
switch-on delay is activated.
Switch-off delay:
Time to switch off output 2 with a delay.
Explanation
If the switch-off pre-warning is activated, the light is not
switched off immediately after the run-on time has
elapsed. The light is first dimmed to minimum bright-
ness within 30 seconds. The run-on time is thereby pro-
longed by approx. 30 seconds. If motion is detected dur-
ing the switch-off pre-warning, then the run-on time is
restarted and the light switches back to the switch-on
brightness.
The light is switched on to a stored brightness.
Specifies the maximum settable brightness.
Specifies the minimum settable brightness.
Basic brightness:
If the function is activated, the light is switched to the
switch-on brightness when motion is detected. After the
run-on time has elapsed, the light is not dimmed off but
is dimmed to a defined brightness value.
24.10.2019
11 / 13