Gira System 3000 Operating Instructions Manual page 10

System 3000
Presence and motion detector 360° top unit BT
Parameters Setting options, default set-
ting
Using the current The current brightness can
brightness be stored in a range of 5 to
500 lx or 1000 lx.
Sensor sensitivity 0, 25, 50, 75, 100 %
Default setting: 100%
Reduced basic On, Off
sensitivity
Default setting: Off
Presence simula- On, Off
tion
Default setting: Off
Activating the day On, Off
operation
Default setting: Off
Activating the On, Off
walking test
Default setting: Off
Activate alarm On, Off
operation
Default setting: Off
Time change On, Off
Default setting: On
Settings only for switch inserts
Parameters Setting options,
default setting
Switch-off pre- On, Off
warning
Default setting:
Off
82599322
Explanation
If the switch-off pre-warning is activated, the light is not
switched off immediately after the run-on time has
elapsed. Triple flashing at an interval of 10 seconds
shows that the light will be switched off soon. The run-
24.10.2019
Explanation
Sets the brightness threshold parameter in the
app to the current brightness.
Individually adjust the sensitivity in 5 steps for
each sensor A–C.
To restrict the detection field, switch off indi-
vidual sensors. To do this, set the sensitivity to
0 %.
Reduced basic sensitivity On:
Reduced basic sensitivity for use in environ-
ments with interference sources.
The function can only be activated after more
than 24 hours of time was saved. In automatic
mode, the times at which the lighting was
switched on are continuously saved. A max-
imum of 60 switching operations are saved
over a period of 24 hours. If more switching
operations take place, the oldest ones are
overwritten respectively. If the presence simu-
lation is activated, the lighting is switched on
at the saved times depending on the bright-
ness. Switch-off takes place after the run-on
time has elapsed. Detected motions prolong
the run-on time or the light is switched on de-
pending on brightness. Times are not saved.
The dynamic run-on time is not taken into ac-
count.
In the setting day operation the device oper-
ates independently of the brightness.
Function for checking the detection field. The
function automatically terminates after
5 minutes.
This function is used to monitor an area for un-
authorised access during absence. If this is
the case, the lighting flashes (1 second on, 1
second off) for the duration of the run-on time.
In addition, a message is sent via the
Bluetooth interface. When motions are detec-
ted, the run-on time is restarted.
Activates automatic summer/wintertime
changeover
10 / 13