Running A Program - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup
Programs
(continued)

Running a Program

In the main screen, the programs you created display in the Run Program panel in the lower right corner
of the screen. (Please refer to Figure IS-28.) To run a program:
1. Touch the program number you want to run at the bottom right corner of the screen.
Note: The first step of the program automatically begins.
2. Press the CONTROL KNOB to advance to the next step after completing a step in the refraction
program.
3. Touch the double yellow bar icon located at the bottom right of the screen to pause the program.
This changes the icon to a green triangle. Touch the green triangle icon to restart the program.
4. Touch the red square icon to stop the program.
16241-101 Rev. D
(continued)
Figure IS-28, Run Program Screen
Pause
Program
Program
Stop
Step
Program
Displayed
43