Modifying A Step In The Program; Deleting A Step From Your Program; Copying A Program Already Created; Exporting A Program - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup
Programs
(continued)

Modifying a Step in the Program

1. Touch the step you want to modify in the Program Listing panel.
2. Touch MODIFY in the menu bar at the bottom of the screen.
3. Make any desired changes to the selected Mode, Eye, or Chart.

Deleting a Step from your Program

1. Touch the step you want to delete in the Program Listing panel.
2. Touch DELETE in the menu bar at the bottom of the screen.
Note: This removes the step from the Program Listing panel.

Copying a Program already created

1. Touch the number of the program you want to copy in the Program Selection panel.
2. Touch COPY in the menu bar at the bottom of the screen.
Note: Copy in the menu bar changes to Paste.
3. Touch the number of the program where you want to paste the copied program in the Program
selection panel.
4. Touch PASTE in the menu bar.
Note: The copied program replaces any previously existing steps in the selected program.
Note: Your program displays in the Program Listing panel. Adjust the program as desired.

Exporting a Program

1. Insert the outside source (USB drive) to which you want to export the program.
2. Touch the Number of the program you want to export.
3. Touch EXPORT in the menu bar at the bottom of the screen.
Note: The exported program is identified by the program number.
Note: Exporting a program to a USB drive overwrites any programs on the drive with the same
program number.
16241-101 Rev. D
(continued)
41