Ports; Setting-Up A Port For Communication With An External Device - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup

Ports

Touch PORTS in the menu bar at the bottom of the Settings Menu screen. (Refer to Figure IS-24 in the
Options/Setup Menu section of this manual.)
The Ports screen allows you to connect external devices the Phoroptor VRx. The ports available on the
Ports screen match the ports at the back of the Central Unit.
WARNING: THE BLUETOOTH WIRELESS CONNECTION TRANSMITTERS OR RECEIVERS CAN BE INTERFERED
WITH BY OTHER ELECTRICAL OR ELECTRONIC EQUIPMENT, EVEN IF THAT EQUIPMENT ALSO COMPLIES WITH
CISPR EMISSIONS REQUIREMENTS.
Setting-Up a Port for Communication with an External Device Connected by a Cable
1. Select an option for the PORT SELECTION (e.g., Instrument 1, Projector, EMR, etc.).
2. In the PORT SETTINGS panel, select the device you are connecting to the Phoroptor VRx.
Note: the instruments available to connect to the VRx are listed in APPENDIX A.
3. Set the Connection Type to "Cable."
4. Set the options for the device you have selected, using the drop-down lists and check boxes
within the PORT SETTINGS panel.
5. Touch APPLY to save the settings.
Note: The settings selected in the Phoroptor VRx must match the settings of the connected
external devices. If the settings are not correct, data will not transfer.
Note: Some devices will display connection parameters that are preset and cannot be modified.
16241-101 Rev. D
(continued)
Figure IS-32, Ports Screen
47