Ametek Reichert Phoroptor VRx User Manual page 23

Instrument Setup
ClearChart 4 Bluetooth USB (
7. Install the Bluetooth USB into the ClearChart. Then power ON the ClearChart.
Note: The Bluetooth USB must be installed in the Clearchart before the ClearChart is powered
ON or the Bluetooth USB will not be paired properly.
8. Press the Menu button on the ClearChart remote and view the Bluetooth address in the lower
right corner of the ClearChart.
9. On the VRx Port page press the Discover button and then it will search for the bluetooth device.
Note: If the desired Bluetooth USB device is not found, press the "Discover" button again.
10. Once the Bluetooth address is displayed, select the address that matches the address on the
ClearChart and click "Pair." (Clicking on "Apply" is not needed after "Pair" is selected.)
11. If unsuccessful pairing the VRx to the ClearChart, check all the connections and repeat the steps
in this section.
16241-101 Rev. D
(continued)
)
Continued
Figure IS-14C, Bluetooth Installed
Figure IS-14D, Bluetooth Address
23