Table of Contents
Advertisement
Retention Clip
Key
System Memory
Installing the SO-DIMM Module
X
X
Please follow the steps below to install the memory card into the socket.
4 5 °
Step 1
Step 2
Step 3
User's Manual | OPS150-CS
Socket Top View
Step 1:
Insert the memory card into the
slot while making sure 1) the
notch and the key are aligned,
and 2) the non-connector end
rises approximately 45 degrees
horizontally. Press the card firmly
into the socket while applying and
maintaining even pressure on both
ends.
Step 2:
Press the end of the card far from
the socket down while making
sure the retention notch and the
clip align as indicated by the dot-
ted line in the illustration. If the
retention notch and the clip do not
align, please remove the card and
re-insert it. Press the card all the
way down.
Step 3:
The clips snap automatically and
abruptly to the retention notches
of the card sounding a distinctive
click, and lock the card in place.
Inspect that the clip sits in the
notch. If not, please pull the clips
outward, release and remove the
card, and mount it again.
Chapter 2
HARDWARE INSTALLATION
18
Advertisement
Table of Contents
