DFI OPS150-CS User Manual page 14

Assembly Heatsink and Fan
X X
Plug/unplug the fan connector, and place the fan in the space between the heatsink and the
chassis wall.
Fan Connector
Config 1: Fan on the right
and heatsink on the left
Note:
The fan cable is recommended to be routed under the fan. Routing the cable over
the top of the fan may result in difficulty in closing up the top cover.
Install/remove the fan by screwing/unscrewing the two M2*4 round-
head screws at two locations — Fan Screw A and Fan Screw B — with
regard to the two heatsink and fan configurations.
User's Manual | OPS150-CS
Config 2: Fan on the left and
heatsink on the right
x2
Config 1: Fan on the right and heatsink on the left
Fan Screw A
Fan Screw B
Config 2: Fan on the left and heatsink on the right
Fan Screw B
Fan Screw A
Chapter 2
HARDWARE INSTALLATION
Fan Screw A
Fan Screw B
Fan Screw B
Fan Screw A
14