Teldat K Seres Installation Manual page 38

Regulatory compliance and safety information
B.4.1.2 Interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
B.4.1.3 Wireless notice
This equipment complies with FCC exposure limits set forth for an uncontrolled environment. The antennas should
be installed and operated with minimum distance of 20 cm between the radiator and your body. Antenna gain must
be below:
Technology
LTE Band 17
GPRS 1 UL
UMTS
LTE Band 4
UMTS (AWS)
GPRS 1 UL
UMTS
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The dis-
tance between different transmitter antennas must be greater than 20 cm.
B.4.1.4 FCC Class A digital device notice
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate ra-
dio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful in-
terference to radio communications. Operation of this equipment in a residential area is likely to cause harmful inter-
ference, in which case the user will be required to correct the interference at his own expense.
32
Frequency
(MHz)
706.5
824
824
1710.7
1700
1850
1850
Maximum Antenna Gain
(dBi)
5.0
3.5
3.5
5.0
5.0
3.0
3.0
Teldat S.A.
Teldat K/KF router